Range of application push-in pipes

Special lengths can be achieved by using a welding end or flanging the shortened pipe.
The simplest application is to use push-in pipes:


Roll the ring seal onto the push-in pipe, push it as far as required into the normal pipe, roll the ring seal back to the lip of the normal pipe and press it by means of a pull ring (without seal).


This connection is not shock-explosion proof. Admissible differential pressure 100 mbar (1000 mm WG, 10.000 PA).

 

Push-in pipe connections cannot absorb any axial forces. The piping must be fixed on site so that it cannot displace.

 

For horizontally installed pipelines a support of the pipes must be planned in the area
of the connection in order to prevent the pipeline from sagging.


As the area between the push-in pipe and the normal pipe is difficult to keep clean,
a push-in pipe is not recommended in case of higher requirements with regard to
hygiene.


In case of formation of condensation the push-in pipe must be mounted in a way, that in the area between the pipes no liquid may gather. The flow direction for air is not defined. Solid materials may only be conveyed from the push-in pipe in the direction of the normal pipe.

 

The sealing of the push-in pipe with rubber bead ring and clamping ring must be used for 3 mm thick piping – but it may be also used for smaller wall thicknesses.

Push-in pipes are not telescopic pipes that can be adjusted during operation.


Cart  

No products

0,00 € Total

Empty your selection ? No Yes

Modify ViderEmpty selection Cart Checkout